Stainless steel door on the film can not tear off how to get?

Solution 1: Many users did not tear off the protective film for a long time, after a summer of exposure to the sun, the glue above the protective film glued the laminating paper and the Stainless Steel Door material together! If it is a large area of protective film, you can use a towel and boiling water for a while, and then hand tear.

Solution 2: If it is very serious, use a hairdryer to blow the protective film with hot air, melt the glue, and gently tear it off. In addition, for the residual glue, continue to blow with the wind, and then use the plastic film to stick the residual glue down. Finally, wash it with water. It's even cleaner.
 

Solution 3: The film on the newly purchased stainless steel door is usually used to protect the door from being scratched during handling. Once it's installed, how do you remove it? First slowly open a seam, and then rub oil into the seam (vegetable oil or lubricating oil can be), after dozens of seconds to tear down, and then repeat the above steps, you can tear off. The rubbed oil (vegetable oil or lubricating oil) can be wiped off after the tape is removed.